Aussiedistiller, Home Distilling, Moonshine, Home Brew

Hey,
Has anyone seen any drawings for a 4" shotgun condenser on this forum for printing out & sticking to the copper for drilling/ cutting purposes?

I've had a look around but nothing jumped out at me.

Cheers.

Just measure and Mark out with a pen before cutting. Reckon that's how most would do it.

I have a template for my 4" RC and 2" PC if that helps you ?

I just printed it out and cut it out

Have a look through the plated column section of the forum. Quite a lot of still builds which will give you an idea and potentially bump into what you are after.

I take it you are planning to build a 4" still, nothing better than pouring over those build threads and learning as much as you can. That info will help you decide on tailoring what you want to build etc.

Thanks guys,
I'll save the PDF & check out that thread. :)