by A&O » Wed Nov 08, 2017 12:07 am
I’m building a bubbler at the moment. My basic design is 4” modular, but what I have pieced together from the numerous builds I have read so far, my condenser is going to be 100mm high, with 7 3/4” internal tubes and a needle valve for water flow.
I was like you, I searched for the one answer with a how too. But it’s not there. I’m up to page 12 of 20 in the plated columns index and I’m learning not only works but also what people have tried the does, doesn’t work. But over time I have learnt even the size of the RC is getting smaller from R&D through trial and error. My design I’m going with seams to be reasonably common that’s tried and tested. But check out some builds, see what has worked for others but also what hasn’t. But in every thread I’ve read, I have learnt at least 1 thing new.
Good luck.
Here’s some photos of my work in progress.
You do not have the required permissions to view the files attached to this post.