Page 1 of 1
Distillers Parrot, using copper plumbing bits
Posted:
Sun Mar 08, 2015 10:13 pm
by phonetic
Here is my attempt making copper distillers parrot, using common copper plumbing bits
Re: Distillers Parrot, using copper plumbing bits
Posted:
Mon Mar 09, 2015 9:42 am
by Meatheadinc
:handgestures-thumbupleft: looks neat
Is the body 3/4" ?
if so be carful that your alcometer has adequate space around the bottom bell/airchamber to allow distillate to pass without causing it to raise due to flow.
I had probs once with a 3/4" and incorrect readings that where fixed with a 1" body tube.
this will all depend on your Alcolmeter
Also it looks like you have provision for a future drain tape :handgestures-thumbupleft:
Re: Distillers Parrot, using copper plumbing bits
Posted:
Mon Mar 09, 2015 9:47 am
by Mad
Good advice meat making mine right now out of 3/4 will keep an eye on that myself.