What to do?

[That Guy]

Is 3v system a 3 vessel? :oops:

Yes, 3 Vessel system. Hot Liquor Tank, Mash Tun and Boiler Kettle.
You could do it all in one vessel, like brew in a bag (BIAB). Less equipment, quicker process, less to clean.
But for me, that would take the fun out of it all.

[That Guy]

Well, I couldn't be happier. I assembled my brand spanking new FDS 4" Modular Pot Still and it is a thing of beauty.

What's the general consensus regarding preparing for my first run?
Do i give all that shiny stainless a soak in Tricleanium?
I've read of people doing a vinegar run?

[PeterC]

Read the newbies section particularly this viewtopic.php?f=57&t=2863

[That Guy]

Ahh, thanks PeterC.

Whats the go with the roll of copper mesh supplied with the FDS 4" Modular Pot Still?
Does it go up in swan neck, the 90° section before the condenser?
Or above the boiler, in the bottom of the hat section?

[Nino]

Ahh, thanks PeterC.

Whats the go with the roll of copper mesh supplied with the FDS 4" Modular Pot Still?
Does it go up in swan neck, the 90° section before the condenser?
Or above the boiler, in the bottom of the hat section?

Above the boiler, it is thick enough so that it won't fall through.

[Buzz]

You will need to clean the copper mesh before using it. Good thread on this here... http://aussiedistiller.com.au/viewtopic.php?f=24&t=7237

[That Guy]

Thanks for all the help, I'm now ready for my vinigar run.... Except for one small problem.
What am I missing between the Keg and the bottom of the hat section?
Is there a connection I havent ordered or will one of those 2" Custom EPDM Seals do the trick?

[bluc]

Epdm seal with no ridge and a tri clamp :handgestures-thumbupleft:

[db1979]

Epdm seal with no ridge and a tri clamp :handgestures-thumbupleft:

I wonder if you'd be better off with only one ridge removed :think:

[bluc]

Doh of course flat one side :oops: :violence-smack: