Aussiedistiller, Home Distilling, Moonshine, Home Brew

Hi
2nd post - was looking around for my new build 3" ccvm for parts

I found a supplier for csst in Aust http://www.cleanwaterproducts.com.au/pr ... ctors.html

$11+gst plus shipping for 1/2" csst x 900mm

So Im waiting on delivery - shipping costs more than the csst! :o

they don't supply 3/8" / 10mm

I hope this helps others

I vaguely remember seeing a condencer coil made from that stuff,is that what ya intend to use it for mate,ccvm plz explain or throw up some pics as I am not quite sure if any of us understand what ya makeing ,it may help us help you better and save you the trouble of changeing something after you are done and find it does not do what ya wanted,welcome aboard by the way plenty ta read in the newbies section and library as well .cheers hillzabilly ;-)

4 condenser coil = correct

My gut feeling is 900mm may be a bit short if ya throwing a lot of power at it or doing stripping runs for a three inch ,presumeing ya going the 50lt beer keg boiler.As with a vapour mangement still the condencer is under a fair bit of load and has to condence everything .cheers hillzabilly ;-)

May be the cheap Bunnings crap I get for showers but they say stainless too. Still have plenty of rust spots over the years though.

this isn't the stuff you can buy at Bunnings, no inner tube made of plastic or rubber that will kink if you bend it

check out the Falcon Stainless website

:handgestures-thumbupleft: