Cooling for 4 inch 4 plate bubbler
Posted: Sun Sep 09, 2018 10:15 am
My present cooling system for a T500 is the following pump from a 2000 litre tank.
https://www.ebay.com.au/itm/65L-Min-3-S ... 2a9db23a0b
I can get approximately 13 l per minute from connection but coming out of condensor on the T500 I only get about 3 l per minute.
The inlet and outlet hose's on the T500 are fairly small.
I would use 1/2 BSP fittings and hose's for the bubbler.
The question I am asking is the following :-
Is 1/2 BSP gate valve from Bunnings good enough to control the RC and PC. ? (Good wide opening no restriction)
Or 1/2 BSP needle valve, which will give greater control, but a restricted flow ?
https://www.ebay.com.au/itm/1-2-DN15-St ... 0878143604
Any thoughts would be appreciated. :smile:
https://www.ebay.com.au/itm/65L-Min-3-S ... 2a9db23a0b
I can get approximately 13 l per minute from connection but coming out of condensor on the T500 I only get about 3 l per minute.
The inlet and outlet hose's on the T500 are fairly small.
I would use 1/2 BSP fittings and hose's for the bubbler.
The question I am asking is the following :-
Is 1/2 BSP gate valve from Bunnings good enough to control the RC and PC. ? (Good wide opening no restriction)
Or 1/2 BSP needle valve, which will give greater control, but a restricted flow ?
https://www.ebay.com.au/itm/1-2-DN15-St ... 0878143604
Any thoughts would be appreciated. :smile: