by Lockyc » Fri Jun 14, 2019 2:31 pm
Yeah, I didn’t want to go that big to avoid smearing, I guess time will tell and I can always take manual measurements the first time.
In regards to the 1/2 bsp fittings, I may just do that down the road, cheers hillzabilly.
The plates are drilled to 1.58mm and I’ve heard of people counter drilling the under side bigger.
Is this necessary? That’s a lot of holes :laughing-rolling:
Hoping to finish off the parrot and weld the flange to the top plate tonight
Do the downcomer lengths look alright about 20mm up top I think.
You do not have the required permissions to view the files attached to this post.