Bender The Bubbler Build Thread

Perforated & bubble cap plated columns

Re: Bender The Bubbler Build Thread

Postby Sam. » Thu Jun 21, 2018 8:35 pm

Fairly sure it's been run, I think Linny was taking the piss because Milky doesn't run it as much as he should :think:
Sam.
Lifetime Member
 
Posts: 10405
Joined: Sun Jul 17, 2011 7:19 pm
Location: South Oz Straya
equipment: Original FSD 5 plate 4 inch modular bubbler SSG with hand crafted plates and parrot by Mac.
18 Gal boiler.
2 x 2400W elements and power controller.
.

Re: Bender The Bubbler Build Thread

Postby Chocko6969 » Fri Oct 26, 2018 5:36 am

Absolutely brilliant mate!

I've been missing from here for some time for a lot of reasons (moving house, new kids, new jobs blah blah), but I'm now finally getting things together to build myself a bubbler. I've just put an order in for some bits from 5 star and can't wait to get started after setting up a basic work shed.
If you don't mind I'll be taking a lot of advice from your post so thank you very much!

Cheers!
Chocko6969
 
Posts: 198
Joined: Sat Jun 25, 2016 11:49 am
Location: NE Victoria
equipment: Bubbler now operational!

Re: Bender The Bubbler Build Thread

Postby Milky » Fri Oct 26, 2018 4:34 pm

Thanks a lot mate for the kind words.

I tried to show as many different things as I could and I hope you got something g out of my thread.

Can't wait to see yours start.
Milky
 
Posts: 349
Joined: Wed Apr 03, 2013 7:15 pm
Location: Brisbane
equipment: Bender The 4" Copper Bubbler
Bender The 50L Electric Keg Boiler (2 xoxo 2000w 5 Star Elements)
Pure Distilling 2 Inch Reflux Still with 30 Litre Electric Boiler (2000w)
Homemade Copper 2 Inch Pot Still Condenser to fit the 30 Litre Electric Boiler.

Re: Bender The Bubbler Build Thread

Postby Chocko6969 » Sat Oct 27, 2018 1:16 pm

Hi again, could I just pick your brain and ask you to explain your cooling? I can't quite see there, does your cool water in start at the bottom of your RC, pass through RC then continue to inlet of PC and out?

Cheers!
Chocko6969
 
Posts: 198
Joined: Sat Jun 25, 2016 11:49 am
Location: NE Victoria
equipment: Bubbler now operational!

Re: Bender The Bubbler Build Thread

Postby Chocko6969 » Thu Dec 27, 2018 7:00 pm

Milky wrote:
20150716_142148_resized.jpg


20150716_142156_resized.jpg


20150716_142136_resized.jpg


20150716_143329_resized.jpg


Hi there, how do you find the x5 3/4" tubes for the RC, I'm considering doing this size too and would like to know if you've had any issues with this opposed to the 7 or 9 1/2" tubes?

Chocko
Chocko6969
 
Posts: 198
Joined: Sat Jun 25, 2016 11:49 am
Location: NE Victoria
equipment: Bubbler now operational!

Previous

Return to Plated Column Stills



Who is online

Users browsing this forum: No registered users and 16 guests

x