ok so stupid question here from me but a must needed to be answered.
I want my blockhead to come out like a tee, although i want it going up say 20 degrees so not quite a tee. that way and re condensed liquid will fall back to the RC and not pool in the pipe section coming off the blockhead.
what degree do i need to set it too? joint angle 70 degrees to have a fall? and just place it where i want it?
this is 70 degrees.
http://www.harderwoods.com/scripts/pipe.php?n=1&f=h1b&paper=letter&units=mm&theta=70&rmd=101.6&rbd=50.8&rbt=0&offset=0i guess a change in direction of 45 degrees would be ok.
this is the 45 degree one but if this makes it level like a T then i would need to go 55 or something
http://www.harderwoods.com/scripts/pipe.php?n=1&f=h1b&paper=letter&units=mm&theta=55&rmd=101.6&rbd=50.8&rbt=0&offset=0what do people recommend for a tee that angles upwards (ascends)
Help need to know what angle to do to get it angled slightly up. ~x(
Want to get on it by tomorrow :pray:
Thanks