still has been working a treat for the last year. last run I noticed it had a few drips before the fore's come out. finished the run off and pulled the PC out.
pressure tested it and it had a tiny pinhole leak at the top where the tubes come through the plate. it pressure tested fine when built and held pressure for 24 hours with no bubbles in a tub of water.
For the life of me i cant get it to stop. if i fix it somewhere it leaks somewhere else. cleaned the thing reflowed it. melted it all off ground up the surface and re soldered it still leaks somewhere. ran the smallest amount of solder it leaks put a heap into it it still leaks... soldered it as hot as I could still leaked soldered it just enough for the solder to flow just dabbing the heat into it and flowing the solder and it still leaks.
i have tried over 40 times (no joke) and it still leaks any tips...?
I think it would have been quicker to make a new PC :cry: