So I went to my favourite scrap yard and bought an 18gallon keg and a piece of stainless pipe.
Got a specially modified 6" ferrule from Mac, as well as all the other bits I needed.Thanks mate. :handgestures-thumbupleft:
It is longer than most. so there is plenty of room for the clamp.
Got a welder to weld me some bits and pieces on.
Here is the result.
Then took to it with a 40 grit flap disc.
Cleaned out the interior and cut two 32mm holes in it for elements.
Decided to cut them below the centre of the keg because inside on one side is a stainless tube that was used for the spear.
By cutting below this the elements are able to butt up against the keg wall better.
Will get a sparkie to wire up the elements as soon as he is able.
The inside needed a bit of a touch up with a flap disc as well.
Could get a grinder inside because of the 6" ferrule.
Also removed most of the stainless pipe that was in there as well... what a job that was, working blind inside a keg. ~x(
DBV