APR wrote:Hi OzKev, I take it the 2 earth screws on the SSR module are also the screws which attach the module to the heat sink so the heat sink is also earthed? Is this correct?
Linny wrote:Careful of the 500kohm jaycar pots ... they have a tendancy to fail regularly . ive seen 2 fail in 10 builds ,,, not very good odds but on a positive they usually carbon up which means they fail in the off position
ekul wrote:Have i shown you these bad boys kev? http://www.ebay.com.au/itm/AC-220V-3800 ... 0999016048 Worked fine for me until I realised that just one 200W element was better (easier) than one element + another one turned down most of the way.
TheMechwarrior wrote:Thanks OzKev,
Could you run the 40A SSR with 2 x 15A parallel inputs to drive 2 x 3600W parallel elements? Using the same design?
This is the one MuleKicker built for me in 2010:
I was hoping to "simply" upgrade the SSR.
Cheers,
Mech.
davecuds wrote:... i have 2 x 25a ssrs lying around, but they will be underated for 32a correct?
davecuds wrote:btw where do you get your pots from. i tried a while back to get a 2w 250k for my PSR25 and i remember that being really difficult. Just having a quick look now and they dont seem to exist.
ENTITY77 wrote:Just wanted to verify that this design would function fine with a T500 boiler?
Won't need it with the refux head but at some point I would like to either make or acquire a pot still head and control over the element will be a must.
ENTITY77 wrote:Just wanted to verify that this design would function fine with a T500 boiler?
Won't need it with the refux head but at some point I would like to either make or acquire a pot still head and control over the element will be a must.
MacStill wrote:ENTITY77 wrote:Just wanted to verify that this design would function fine with a T500 boiler?
Won't need it with the refux head but at some point I would like to either make or acquire a pot still head and control over the element will be a must.
you should consider this :handgestures-thumbupleft:
Jayson_Black wrote:MacStill wrote:ENTITY77 wrote:Just wanted to verify that this design would function fine with a T500 boiler?
Won't need it with the refux head but at some point I would like to either make or acquire a pot still head and control over the element will be a must.
you should consider this :handgestures-thumbupleft:
Err. every time I try to view "You should consider this" Forum asks me to log in, when I am already logged in. Glitch maybe?
GLA :D
Users browsing this forum: No registered users and 2 guests