T500 coversion

Pot still design and discussion

T500 coversion

Postby taffy4x4 » Fri Jun 12, 2020 8:09 am

Isolation is a terrible thing, I got so bored that I rummaged through the shed and found a piece of 2" copper the same length as my T500 colum. My question is, is the height of a pot still column from the top of the still to the elbow important, can it be any length, or should it be as short as possible, or is there an optimum length. Any advice would be appreciated. Cheers.
taffy4x4
 
Posts: 14
Joined: Sat Apr 27, 2019 11:54 am
Location: S.E. QLD
equipment: T500 reflux and home made stainless steel and copper 10lt pot still

Re: T500 coversion

Postby bluc » Fri Jun 12, 2020 8:42 am

I dont think height really matters on a 2" other opinions might vary. Mine was only about 100mm high before turning and going into pc.
bluc
 
Posts: 7724
Joined: Tue Apr 14, 2015 5:47 pm
Location: sunshine coast
equipment: 2" pot with 2" shotty 400mm long 5x 1/2" on a t500 boiler.
50l keg boiler 4" still mount 4" sight glass 1" drain..
4 plate 4" bubbler, 600mm packed section

Re: T500 coversion

Postby Professor Green » Fri Jun 12, 2020 6:57 pm

You will get a little bit of passive reflux if you have any sort of height to your pot. Not necessarily a bad thing. Have a look through some of the other DIY builds in this section for some ideas on sizes.
Professor Green
Mentor
 
Posts: 2282
Joined: Fri Apr 17, 2015 1:10 pm
Location: Victoria
equipment: FSD 100 litre milk can with 2 x 2400W elements
FSD Neutraliser
FSD Carter Head
12 litre double boiler with 2400W element


Return to Pot Stills



Who is online

Users browsing this forum: No registered users and 6 guests

x