by hsv8 » Thu Dec 03, 2015 9:33 am
Thank you for the input everyone.
I understand that a gate valve is easier to control, and believe me, I've called every plumbing store around me to try and find one made from copper or staino. However, they all seem to be made from brass. Any tips on where to find a copper or staino gate valve? I really have tried! The only reason I've gone for a ball valve in the plan is because I've just about given up on trying to find a copper or staino gate valve.
Thanks for clearing that up about the piping Scythe, that helps a lot, and makes perfect sense! Will look into needle valves as well.
Mech, I based the column height off some similar designs I have seen. I was not aware of the theory "Height = 30x column ID". But yes, if that's the case, and it will increase the efficiency, then I will definitely look into making it taller. Might start by checking my ceiling height, as you suggested.
Cheers,
Hsv8