Ok I know this has been dragging on for ages, lots happening at the moment.
First photo is when it's been cleaned up, just need to check it on the column for fit. This doesn't have to be perfect as I use filler wire, if you are fusing you would need to have a nice tight fit. Any gap up to say .5mm is fine. Hole is drilled in the condensor arm, offtake cup was done previously.
Second photo was the initial cut with the cutting disc, leave heaps of beef on the cut (less chance of going to deep and having to remark and do it again.
I'll take a photo of it layed out just before it's welded and then as it's being welded.
Easy still to make and runs very well.
ready to fit (676 x 449).jpg
You do not have the required permissions to view the files attached to this post.