Hi brains trust , me again ! :D
This time I need your opinions about the clearance between the outer coil and the inside wall of 3" tube ( I've been experimenting with this and have got it down to 1/16 "- 3/32" . Is that too close ? Is that too far? ) and the clearance between the coils themselves, not to get confused with the spacing between the windings of the coil, Is there an optimum clearance I should aim for in both areas ? :?
I am trying to get 4 coils of 1/4" tube ( inside each other, with every second one counter wound ) into a 3" pipe for this condenser, each individually soldered to the in & out lines
( I like to challenge myself :think: :crazy: :crazy: )
Then I gotta work out how long to make it :think: :think:
I know I will get good, reliable info from you lot :laughing-rolling:
Thanks in advance
cheers
Stubbydrainer