Hey Guys
I pretty new around here but your going to see a lot more of me.
My new Keg boiler is going to need a drain point and I have looked an everyone's photos that they have put up.
I don't want to raise the keg up to clear the drain and I also don't want to have to tip the keg towards
the drain if its mounted higher. I want to leave the bottom ring intact.
My idea is pretty simple I want to weld a tube into the keg that drops right down into the very lowest point in the centre(on my keg anyway)
the drain point will be maybe 2 inches higher than this point once were all said and done so I plan to just put my air compressor hose into a point
on the top of the keg and force everything out the drain. it wont take much pressure maybe 2 - 5 psi and it will only be to drain the last 2 inches
I am thinking to weld in a 3/4 stainless socket/ threaded union and thread the inside dip tube into it and screw a tap in outside
Any ideas on how that will work would be great