Zzpop wrote:Try a bit of cooking oil on the gasket then tighten
Zzpop wrote:Try a bit of cooking oil on the gasket then tighten
Zzpop wrote:Hmmm maybe give the keg a smack to flatten it where it is catching legs are pretty tough
BennyHiggo wrote:It's near the top of my 'to do' list after my last run .... Heat up in the warm weather has only been taking 45 mins .... Last run was quite a bit cooler and took over an hour to heat up .... That's just wasted time ~x(
rumsponge wrote:just as an addon: you have to make sure that the entire still/boiler is grounded NOT just the ferrule.
EziTasting wrote:rumsponge wrote:just as an addon: you have to make sure that the entire still/boiler is grounded NOT just the ferrule.
Glad I asked!
Just had a closer look, my heaters don't sit in a guard like that. I have drilled a hole into the back of my boiler and my elements are inserted from the inside thru to the outside, hence Weldless...
So mine don't have that little screw! :oops:
So, ... what do I do?
Users browsing this forum: No registered users and 0 guests