Doubleuj wrote:Holy crap Magnus, it took me three reads of your pics to realise how you made the plates 8-}
Machining and drilling a solid piece then cutting slides off is awesome, definitely will get all the holes lined up nicely :handgestures-thumbupleft:
The middle plates have stumped me though.. Are the smaller in diameter than the inside of the pipe?
Doubleuj wrote:The middle plates have stumped me though.. Are the smaller in diameter than the inside of the pipe?
Magnus wrote:That's it Warra, wanted to run as traditional in pot mode. The thumper has an extra 2" connection on top as well so I can connect a valve and small tank to hold a few liters of honey or other liquid flavor and shoot into the thumper during a run.
warramungas wrote:My thoughts exactly. But I was going to put it at the top of my plates when I got one to allow it to 'Dribble' down the column slowly and accumulate in the thumper gradually. Maximum bang for buck (I hope).
Users browsing this forum: No registered users and 9 guests