by Amfamora » Sat May 06, 2017 11:33 am
Hi Again All,
At the point of trying to decide where to place the hole for the second element. Im considering the spot marked with the x but being on a curve creates a couple of mm gap between the bottom of the ferrule and the wall of the keg.
Will whoever I get to weld this all up for me be able to span a couple of mm gap or does it need to be as flush as possible. No welding experience so sorry if it seems like a stupid question.
Do I need the holes big enough the ferrule needs to sit inside them to avoid this problem? Can I put them closer together at the same height almost parallel then bend the elements so they wont touch?
Doing it as I am, after the welding I do plan to have the holes ground back inside the ferrule with a die grinder :)
Cheers
You do not have the required permissions to view the files attached to this post.