texta wrote:if i was making this collar again i would be making it out of brass ,much easier than stainless .i made it this way so that there is nothing going through the hole in the lid causing restrictions , this way it is the full 2" all the way through and there is very little weight in it .
woodduck wrote:Yer but what if you build a bubbler later :think:
400 would be ok but 500mm and you can use it on your next upgrade :handgestures-thumbupleft: but yes watch the weight, someone with a t500 might be able to help here
scottyd72 wrote:texta wrote:if i was making this collar again i would be making it out of brass ,much easier than stainless .i made it this way so that there is nothing going through the hole in the lid causing restrictions , this way it is the full 2" all the way through and there is very little weight in it .
That is just pure genius right there!
I bought a spare lid for my boiler and tried TIG'ing a flange to it, but as I'm still learning to weld I botched it, so I now need to buy another lid and try to weld a stainless 3" flange onto it.
bluc wrote:scottyd72 wrote:texta wrote:if i was making this collar again i would be making it out of brass ,much easier than stainless .i made it this way so that there is nothing going through the hole in the lid causing restrictions , this way it is the full 2" all the way through and there is very little weight in it .
That is just pure genius right there!
I bought a spare lid for my boiler and tried TIG'ing a flange to it, but as I'm still learning to weld I botched it, so I now need to buy another lid and try to weld a stainless 3" flange onto it.
Just buy an adapter from mac
Users browsing this forum: No registered users and 53 guests