Today had been a bit of a busy day now I have received some goodies in the mail.
6E51D750-8143-4FA4-BD30-F824F6AD256A.jpeg
So I’ve cut the keg up a bit. I’m going to run the keg upside down. Plan is it to retain the existing fill point and use it as my drain. I have a 2” 90* bend with a 1 1/4” threaded adapter which with a reducing nipple have a 1” drain valve.
AB81A878-8EC3-48D2-AD6E-ADFB3D59FEBC.jpeg
I have cut the first of the wheels and fit in place. I needed to notch the rim to allow the wheel bracket to fit properly.
83F6209C-7815-4339-AB13-C62D4A3D6846.jpeg
8B1A7A75-AFB1-49E8-89BF-3D3BA6E66B01.jpeg
I think I may run into a problem with the 4” ferrule placement. I think they may be too close together to get the triclamps on/off. I figure the column won’t come off all that much and I’m only going to have a cap on the other for filling. I’m seriously considering changing it to a 3” to make sure everything fits with a little wriggle room.
Tomorrow I should have the other wheels cut and in place then I need to decide how to weld or solder together.
You do not have the required permissions to view the files attached to this post.