by scythe » Sat Dec 23, 2017 6:33 am
I first read the 2nd page of this thread amd then had to go back through but my first thought was to make something copper like that glass thing.
2" ferrule off the boiler, spool piece to get a bit of height, 2" valve, then a 2"-4" reducer, short section of 4" then either a 4"end cap or another reducer back down to 2".
I did not consider the need for the "breather" tho so a length that runs from the 2" spool to the top of the 4" section will cover that.
Using 4" to give you volume but may not really be required because really it only needs to hold 500ml max.
[Edit] need 200mm of 2" to hold volume of 360ml
/edit
But adding it above the RC aounds like an even better idea, especially if you have a blockhead that you can put a gin basket in.