bluc wrote:I normally mill it while strike water is heating up.. :handgestures-thumbupleft:
bluc wrote:in my 60l tun the falsie is approx 1.5mm hole 5mm centres. :handgestures-thumbupleft: Not sure how they measure it but looks like first one in your list 1.6mm hole 2.54 centre(becasue holes are staggered one row half into the gap below if that makes sence. Between holes on same row is approx 5mm.. :-B
bluc wrote:Sounds like you nailed it :handgestures-thumbupleft: method is fine. Just going off first sparge you got 68% effeciency not bad especially on first go :D sounds like you did well with your malt also.
Users browsing this forum: No registered users and 8 guests