Hi Guys,
I will start a build thread when I final nail down the last few questions I have while conducting some testing before I settle on the final design of my up and coming bubble build. I did some R&D on making my plates today but got a bit heavy handed when drill press machining my plates that will sit within the a s/s ferule with the inside trimmed out of the gasket. My question is how critical is the size of the finished plate, I did two tests - 105mm and 106.5mm - would the 105mm be ok or do they need to be more like 106.5???.
My second question is my plan is to have 5 * 1" bubble caps with a 3/4" risers and 1" downcommer. If later on I added more plates ie for a neutral run etc could I used some plates in addition that were 2.5" bubble caps with a 2" riser and with a 1" downcommer??? or would this create problems??
Thanks
Clinton