by Maxxx » Fri Nov 22, 2019 4:30 am
Hi Teitan
I had that problem with mine in the beginning too.
Fix for me was initially wrapping the edges of the plates in Teflon tape so it did not move/rotate at all in the gasket and also installing 8 rods.
Before you go drilling holes for extra rods or anything just double check the edges of each glass section, they should fit snug within the gasket groove, you should not really have to stretch the gasket much if at all to fit the glass.
A couple of my glass sections were out of round and not perfectly flat on the ends from the flame finishing process and I could only just get the gaskets to stretch over them, this was eventually found to be the problem which was solved by swapping them out.
You do not have the required permissions to view the files attached to this post.