by NeddyJ » Thu Jan 23, 2020 11:59 am
For the condenser itself, i bought a 10m roll of 9.5mm copper which i ended up using 6m of.
For the cap i cut down the middle of some of that copper pipe i had (I know it hurt me too) and annealed it with my home made torch, flattened it, and made it round.
The caps with the filed in grooves are the cap for the venting hole on top, which i only ended up using one of as you can see.
Finally i soldered it all up with a standard brass fitting which can take a standard snap on attachment for water.
Also i originally wanted to stretch out the coil a bit, though a couple problems got in the way. Firstly it was hard as heck, then i also had limited room to stretch it as it would start to interfere with the lower part, and lastly when i tested it with water and both water and vinegar, it was able to easily knock down those vapours with no problems at all.
You do not have the required permissions to view the files attached to this post.