There’s lots of tips in most of the bubbler build threads but the most common way to cut out your holes is to mark out the cut then drill a heap of small holes around the mark, then connect the dots with a dremmel or similar.
Drilling stainless is hard though, you’ll need a few drill bits, some cutting fluid or WD40, low speed and high pressure.
Take your time and take breaks, if the drill bit heats up once is wrecked.
I managed to find a mate with a plasma cutter that made easy work of cutting out my holes.
Plus I’d suggest flipping the keg and using the existing hole as a drain and put 2 x 4” ferrules on the top (old bottom)
One for a fill port and one for the still. Just make sure they’re spaced far enough apart so the clamps don’t hit.
Br00ksy wrote:
For my pot atm i just running the tap full blast and dumping the outflow into my downpipe to be drained back into the tanks :D
Cheers
Users browsing this forum: No registered users and 49 guests