Looks great GINKING!
I have just started a keg build myself but I'm doing the upside down one. Who did you end up using for the welding? And what did they charge? (If I'm allowed to ask that?)
Cheers.
GINKING wrote:Hi Stryda,
I found a guy on Gum tree who was willing to do it for around the $200 mark.. It took him 4 hours so it was a lot of work. I had 2x 4" holes, 2x 2" holes and 1x 1" hole.
Everyone else was quoting $400+...
If I had my time again I would probably just buy a 50L boiler.. much easy and less things to worry about...
Cheers,
Ginking
GINKING wrote:Nice work Stryda,
Now you'll need to soak those welds in a citric acid bath for a few days to clean up the welded area from heat tint.
Have a look at this and also search the forum..
http://aussiedistiller.com.au/viewtopic.php?f=17&t=2086&p=27533&hilit=heat+tint#p27533
Cheers,
Ginking
scythe wrote:Also for future drillers out there, mix water and metho 75:25 for a better coolant.
The heat is removed when the coolant evaporates.
Users browsing this forum: No registered users and 10 guests