Hey guys!
I finally picked up my first still on the weekend, it is basically a 25 Litre twin element boiler and reflux condenser, much the same as a Turbo 500 setup just a few years older I believe. I did a quick test run with it lastnight just to see how everything runs just using water instead of my wash...and I noticed a pretty large amount of steam escaping where the boiler connects to the condenser...Im just wondering if there is any silicone seals or some kind of seal I could use/ make to sit in between the 2 pieces? I notice the newer models have a few clips tgat fasten the 2 pieces together, mine has more of a 1 piece clamp much the same as a large paint tin uses? I may be able to crimp it more to tighten down more etc but just thought I would ask. Thanks guys, Al.