Smbjk wrote:Day off build, build build. Built and installed a siphon tube so keg can empty all the way. Had to tweek the angles so I could get the elements as low as possible. Keg empties all way to lowest point :D And shit my keg is dirty inside have used in a month or so been at the welders. Welder did a good job so pretty happy. Post more progress later and hopefully be finished today or tomorrow :pray:
Smbjk wrote:Done! My baby has found a new mate :D
whiskeyshiner wrote:Smbjk wrote:Done! My baby has found a new mate :D
Thats so schmicko mate you done well :handgestures-thumbupleft: got a quick question if you dont mind where the castor wheel screws into the tube have you welded a nut inside ? I was going to weld one in but i thought it would be hard to get straight and welding would hard. Did you use another method
Smbjk wrote: Hi whiskey. The castors have a sleeve that fits into the box tubing. Easy as no welding involved :D
TheMechwarrior wrote:Bloody top job mate :handgestures-thumbupleft: sleep well at night, you've done yourself proud. You now have a family heirloom that you can pass on from generation to generation.
TheMechwarrior wrote:Sounds like some beautiful father and son bonding right there ;-) . My boy is not long out of toilet training...but I want teach him to build with copper starting in a couple of weeks :D
punchy21 wrote:Top job from start to finish mate :clap:
I think you may have just inspired me to build a bigger boiler... But where to get an 18 gallon keg :roll:
Smbjk wrote:Just a quick thanks to all the guys on the forum that have helped with this build :clap: mac your elements are fantastic, tried them yesterday with a half keg of water and boilded in less than 15mins :D beautiful pieces of kit :handgestures-thumbupleft: and thanks punchy for your controller design, simple and efficient :handgestures-thumbupleft:
And also the misses has let me keep my setup permanently setup out the back so no more dismantling and also I get to look at it every day :handgestures-thumbupleft:
Users browsing this forum: No registered users and 11 guests