Little bit of vapour out of the condensor?

[busman]

So I'm doing a strip run through my pot still, its belting along nicely, putting out about 5.5 to 6 litres an hour, but there is always just a little bit of vapour coming out the end of the condensor with the product. I'm running plenty of water through the liebig, its barely warm coming out, just wondering if a little bit of vapour is normal or if I'm wasting perfectly good booze?

[R-sole]

You are wasting good booze and making a dangerous enviroment.

Push a little bit of stretched out scubber up the length of it with a stick of solder or some wire will help, but otherwise turn the heat down and strip slower till you get it solved.

[Cane Toad]

i
I had the same problem too Busman,but I gas the gas sitting on 3/4 :laughing-rolling: :laughing-rolling: :laughing-rolling: sounded like an aircraft carrier at battle stations,turned the herbs down and problem solved :text-lol:

[busman]

Thanks guys, will make sure I do that for next run :text-thankyoublue:

[wynnum1]

Try using some ice to cool down where you collect a 2 l bottle of ice or put your collecting vessel in an ice bucket only problem hot into cold may crack glass stainless steel collector might be best .