Almost impossible to find anything pre-wired.
Now before anyone jumps on me & explains the importance of a DIY wiring job of my elements, I will be getting my work checked over by a qualified electrician to confirm the following questions to my wiring. I've found it frustratingly difficult to get an electrician here to do this job as their either just too busy or the jobs basically of no value to them. That leaves me with very little options apart from having a go myself. I've wired up quite a few STC controllers, made extension leads & replaced 10A plugs on cords with no dramas thus far. The elements I'm trying to wire are the FSD 2400W ULD elements so I'm hoping a sparky can advise whether my idea of wiring these elements is on the right track.
I've been advised that it's an A/C cct so polarity does not matter.
I was looking to put a ring terminal ( Live ) onto pin 1
A ring terminal ( Neutral ) on pin 3
Then a ring terminal ( Ground ) on the grounding bolt that comes with the FSD Element guard kits.
Resized Paint Elements.jpg