2" modular pot build with shotgun condenser
Posted: Wed Feb 01, 2017 4:02 pm
1m of 2"
3m of 1/2"
A 2" 90 degree elbow
Reducers
Going to modify the 2" pot my mate and i built that's based off a HD design and make it modular with plans to use it down the track with 4x 4" fsd bubble plate Ts. I have a 4-2 reducer for my keg mount and a pile of other goodies coming from fsd (thanks Sue) such as tri clamps etc so the keg build is sorted and I'm pretty sure I have everything now to get this done. Keg will have an fsd 2400 element and a second element port blanked with a clamp and plate ready for a second later on. As I read somewhere Zak said Future Proof it! 4" mount and 4" sg/fill port and 11/2" butterfly valve drain. At some stage I'll wrk out a controller, been reading threads and am just super confused, electrickery is evil.
A few questions I have.
1. I only have a pipe cutter so should I buy some plate for the ends of the shotgun? Or is there a way I can cut a section of the 2" off and split it/flatten it and use it that way? I've read that guys do that I'm just not certain how to achieve it.
2. I don't have any 1/4 for easy flanges as I could only buy it in length or coil at tradelink so I didn't wirry. Can I use half inch? I'll have 500mm left over after the 5 internals of the shotgun.
That's pretty much it!