by Kenster » Wed Jun 21, 2017 4:48 pm
Currently running a 3" copper pot (1300 high) off a T500 lid(& boiler). In addition to the col height i have a 300mm ss section migged onto the lid with a tri, so i can swap over to my reflux when needed. Heres the question...The 300 section on the lid is packed with the typical ceramics supplied with the T500. When i run in pot mode i do not remove this packing. Will this have any real impact on flavour loss due to some kind of reflux or is it OK to leave it in. Honestly, i am just too lazy to remove it... is that doing my flavours an injustice. Also, i have not tried 'both' ways (with & without) to compare. Just hoped some theory might set me straight.