woodduck wrote:My guess on the soldering is, it looks like it might be a bit too hot. If the flux goes black it's too much heat. Try less direct heat, heat the pipe above instead and heat right around the pipe to start with so the whole pipe is warm, this should help.also did you flux both sides of the ring and pipe?
MacStill wrote:I aim the point of the flame 15 to 20 mm above the ring, straight at the pipe :handgestures-thumbupleft:
CyBaThUg wrote:planning to build a bigger boiler it will hold roughly 120 litres but will only fill to 100 litre mark and want to know if this can be run on electricity or will i need a lpg burner
Return to Hardware Research & Development
Users browsing this forum: No registered users and 82 guests