I have a few litres of flavoured neutral alcohol in the shed and feel like I'm ready to move onto the next step of my hobby. Building my own still.
The hope is to build a pot still and keg boiler, then while I'm getting the hang of the new rig, slowly put together some 4" bubble tees and maybe a botanical basket.
So I have accumulated nearly all my supplies, haven't sorted a fill or drain port, waiting on clamps and haven't got reducers for the parrot or end of PC.
Snapchat-1927242753.jpg
Snapchat-1520665058.jpg
Snapchat-1853554351.jpg
I couldn't find any emery cloth at the big green shed? And the only solder I could find was this 2 pack (which cost an arm and a leg) and the coiled up stuff (soft solder?)
So here's A plan
Snapchat-1889316908.jpg
I can either make a simple pelican and after I have the bubble tees figure it out then.
I can make a modular pelican.
Or make a plain modular inverted U.
Thoughts? I couldn't proceed without input because I value all of your knowledge and opinions
Mitch
You do not have the required permissions to view the files attached to this post.