woodduck wrote:Go 2" shotgun mate cause you can use that if you upgrade to a bubbler. A 2" will be fine on a 4" pot or bubbler :handgestures-thumbupleft:
You could go 2" pelican off your T500 boiler and buy the adaptor from 5 star so it clamps straight onto the lid.
woodduck wrote:I wouldn't put a 4" on a T500 boiler, way to heavy. What I was getting at is that a 2" shotty will nock down the vapor from a 4".
woodduck wrote:Simplest would be, build a 2" shotty condencer, 2 90deg elbows a 500mm 2" riser with a easy flange on the bottom that will triclamp straight to the keg :handgestures-thumbupleft:
FilthyPhil wrote:woodduck wrote:Simplest would be, build a 2" shotty condencer, 2 90deg elbows a 500mm 2" riser with a easy flange on the bottom that will triclamp straight to the keg :handgestures-thumbupleft:
I know this is an old post but I was researching the same question for my build.
How can a shotgun condenser be the simplest? It seems like a lot more work than a copper coil or a liebig condenser.
RC Al wrote:Im using a 6 foot liebig, good for 12 litres an hour so far, more heat to come next stripping run, I think I will find the limit next time with the new gas regulator I just got :music-deathmetal:
RC Al wrote:Damn it Dan , I want to make 2 more liebigs now... in the thin stuff and with/without the turbulence crimps.... I have enough crap to solder already :angry-banghead:
Users browsing this forum: No registered users and 45 guests