BigRig wrote:not sure if this is a stupid question but I have a 10A double power point in the brew shed. I am assuming it means each power point is 10A.
The elements will be wired in to 10A leads. Will I be able to run 2 x 2400W elements on the 1 power point or will I need to run them on separate power points ?
BigRig wrote:It was installed for a hot tug, had heater and water pump on it.
I will get an electrician to come out and look.
Amberale wrote:My sparky reckons I am good to run 2 2400w elements off one circuit
howard wrote:my 10A heavy duty extension cable was showing signs of deterioration running 10 amps on spirit runs, both ends replaced.
10A switch on the boiler showing signs of deterioration running 7.9A for long periods, new 15A switch ready to be fitted.
Users browsing this forum: No registered users and 1 guest