Sam. wrote:
5% Citric acid solution in hot water will do the trick
WhiskeySour wrote:I'm also building something similar, it seems Lesgold has inspired a few of us!
Reading this post has given me a kick in the arse to get mine finished, hit a brick wall on 1/4in for my easy flanges and the condenser coil. Going to have to do some digging
tacman1970 wrote:Stryda, how much 1/4" tubing did you need for your RC? I've got plenty (30m) but can't find anywhere that gives a reasonable detail on the length required. I'm building a CCVM like you and the best guess I've come up with is somewhere around 6 - 7m of tubing.
Stryda wrote:when the 4" fill port was welded on it warped slightly, enough for it to leak. I found it when I sealed it up and flipped it to acid bath the welds. Took it back to the guy that welded it for me and he managed to get it pretty flat, enough for it to seal up with an extra crank on the clamp. Don't think I'll be able to put a sight glass on that one though.
Stryda wrote:tacman1970 wrote:Stryda, how much 1/4" tubing did you need for your RC? I've got plenty (30m) but can't find anywhere that gives a reasonable detail on the length required. I'm building a CCVM like you and the best guess I've come up with is somewhere around 6 - 7m of tubing.
Hi mate, I can’t quite remember the exact amount but I think you’re pretty much on the money. If you have that much it shouldn’t be an issue, allow a bit more than you think you need and make your coils. You can always cut off the excess.
Return to Hardware Research & Development
Users browsing this forum: No registered users and 12 guests