rb20Siliva69 wrote:That is f'ing sweet... Going to have to take the plunge my self!
Did you have plans you made up to go of for dimension's etc?
Well done mate... Well done!
Thanks mate :handgestures-thumbupleft:
Didn't have plans made up, except for scribbling things out on paper as I went. It was all in my head from various other builds and researching here on the site. I can give you a quick run down though:
- 4" diameter
- Modules 140mm high
- Downcomers at 25mm
- Sight glasses sit only 'just' above that 25mm mark
- Every module is made using easy flanges, including sight glass ports
- RC is 3", 130mm high, with 4x 1" tubes
- PC is 2", 500mm long, with 5x 1/2" tubes
- Parrot is 1" body, and made only just big enough to take the smallest alcometer available (165mm) to 100% ABV on scale
- Plates are perforated plate style, with 1/16" or 1.6mm holes, spaced in a 5mm grid pattern.
- Approx 290 - 310 holes per plate which constitutes 7.6% - 8% wet plate surface area (5-10% is the operating range, with 8% being considered ideal)
There's the plans :D If you don't understand any of that, start reading and you'll be building your own in no time :handgestures-thumbupleft: