So I made a start on the PC today.
Have just enough 3" to complete it.
Start hammering out the flanges, in my own little world.
Stand back and admire the work.... orsh, forgot to put the 1/4" rings on before starting the second flange didn't I. :angry-banghead:
Hmmmm - Na.... not going to cut one flange off to get the rings on, not enough length in this pipe as is..... think, think :think:
OK how about this, cut the rings and make them a good fit.... don't solder them up.
Bend them and slip them over the flange.
DSCN3922 (Copy).JPG
Press the ends past each other and tap until they look right.
Bend the ends so they touch. :D :handgestures-thumbupleft:
DSCN3924 (Copy).JPG
Just got to remember not to do this too often :oops: 8-}
DBV
You do not have the required permissions to view the files attached to this post.