by bluc » Tue Jun 26, 2018 2:29 pm
Bunnings also do oxy/acetylene bottle swap setup. I brazed but its not needed. I sat modules on a gas bbq and helped it along with a mapp gas torch 5% solder. Was a pain in the ass in places like rc where there is a lot of copper in a small space which acts like a heatsink, and long sections like pc .
I ended up buying a torch like woodduck linked to and used that along with the map torch and it worked better than bbq burner.. :-B
Last edited by
bluc on Tue Jun 26, 2018 2:29 pm, edited 1 time in total.